Ženske ljetne ležerne hlače od čistog lana širokih nogavica

1. Chest: Place the tape close under the armhole and measure from side seam to side seam.
2. Waist: This is the narrowest part of the waist. Place the tape from side to side directly at the waistline.
3. Hip: Place the tape approximately 7–9 inches below the natural waistline and measure from side to side at the hip line.
4. Flare: This is the length of the flare of your dress. Flare is the bottom wide length of your dress.
5. Strap to Hem: This is the length from the top of the strap down to the hem.
6. Waist to Hem: This is the length from the top of the waistband to the bottom of the hemline.

1. Measure your chest: Stand up straight with your arms hang down in a relaxed, natural pose. Measure around the fullest part of your chest. Tight up under the armpits and over the shoulder blades.
2. Measure your waist: Stand up straight in a relaxed, normal position. Run the tape around the narrowest part of your natural waist. This is usually where the belly button is.
3. Measure your hips: Stand with your feet together. Measure around the fullest part of your hips and rear. This is typically midway between your crotch and your belly button.

1. WAIST: For measuring the waist first button the pants up. Next spread the pants flat on the surface, and remove any fullness and wrinkles from it.

2. FRONT RISE: With the pants buttoned up, spread the pants on the floor or table; next remove all wrinkles, and measure this region by starting from crotch seam spot to the spot of the waistband.

3. HIP: Measure across the hip area, this is in most cases 1 1/2 inches below the zipper.

4. THIGH: Starting at the crotch seam and ending 1–2 inches below the hip area.

5. LENGTH: With the pants buttoned up, spread the pants on a table, floor or any other flat surface, with outseams on both corners. After removing all wrinkles and any fullness, measure the length from the top of the waistband.

6. KNEE: Next remove any wrinkles and fullness if present. Measure across the knee area.

7. INSEAM: Having the pants buttoned up, spread the pants on a surface flat. Now measure the inseam gap from the crotch, at the spot where the front and back seams meet, exactly where, depends on the length you desire ultimately.

8. LEG OPENING: Now in the last step follow the same pattern as the previous steps, which is spread the pants on a flat surface e.g. table or floor. After removing any fullness or wrinkles, start measurement beginning from one side of the leg opening to the other side of the leg opening.